Renson LAPURE Manuel D'utilisation page 86

Moving the end points of
the screen roof (with RTS
control)
A. Go to the endpoint (upper or lower)
which you want to move.
B. Press more than 5 sec. on the UP-
and DOWN-button till the Fixscreen
makes a short movement.
C. Choose the new (upper or lower)
endpoint by pressing the UP- and/or
DOWNbutton.
D. Press more than 2 sec. on the MY-but-
ton till the Fixscreen makes a short
movement.
Test the new endpoint.
Select personal position of
the screen roof
A. Place the bottom bar in the desired
position.
B. Press the MY-key until the bottom bar
briefly goes up and down as confirma-
tion.
C. The next time you press on the MY-
key, the fabric will automatically move
to this position.
Copy Telis hand-held
transmitter programming
to another Telis hand-held
transmitter
A. Select the channel you wish to copy
on Telis 1 (bladed roof, fixscreen, LED,
etc.).
B. Press longer than 3 sec. on the PROG
button at the back of the Telis 1 re-
mote until the blades move back and
forth, the fixscreen shortly moves up
and down or the LED flashes.
C. Select the desired channel on Telis 2
to which you want to copy.
D. Press briefly on the PROG button on
the rear of the Telis 2 remote.
86
0,5 sec.
ENDPOINT
ENDPOINT
A
ENDPOINT
ENDPOINT
C
A
0,5 sec
C
A B
TELIS 1
TELIS 1
C D
TELIS 2 TELIS 2
> 5 sec.
B
> 2 sec.
NEW
NEW
D
> 2 sec
B
> 3 sec.
0,5 sec.