Operational Cautions - Metabo HPT CR 18DA Instructions De Sécurité Et Mode D'emploi

English
6. LED light warning signals (Fig. 27)
This product features functions that are designed
to protect the tool itself as well as the battery. While
the switch is pulled, if any of the safeguard functions
activate during operation, the LED light will blink as
described in Table 5. When any of the safeguard
functions are triggered, immediately remove your
fi nger from the switch and follow the instructions
described under corrective action.
Safeguard Function
Overload Protection
Temperature Protection
Low Voltage Protection

OPERATIONAL CAUTIONS

Resting the unit after continuous work
(1) The power tool is equipped with a temperature
protection circuit to protect the motor.
Continuous work may cause the temperature of the
unit to rise, activating the temperature protection
circuit and automatically stopping operation.
If this happens, allow the power tool to cool before
resuming use.
(2) After use for continuous works, rest the unit for
15 minutes or so when replacing the battery. The
temperature of the motor, switch, etc., will rise if
the work is started again immediately after battery
replacement, eventually resulting in burnout.
18
Table 5
LED Light Display
On 0.25 second/off 0.25 second
Fig. 27
Corrective Action
Remove the cause of the overload.
Allow the tool and battery to thoroughly
cool.
Recharge the battery.