Numark NS7III Guide D'utilisation page 9

Pad Mode Controls
26. Pads: These pads have different functions on each Deck depending on the current Pad
Mode. These pads are the same pads used with Akai Professional MPCs
velocity-sensitive (in certain modes only), durable, and easy to play. In this User Guide,
when referring to specific pads, it will refer to the numbers as shown here.
27. Parameter < / > : Use these buttons for various functions in each Pad Mode. Press and
hold Shift and use these buttons to access secondary parameters.
28. Cues: This Pad Mode button switches the pads between two modes: Hot Cue Mode (red)
and Hot Cue Auto-Loop Mode (orange). When the button is unlit, the first press will always
select Hot Cue Mode.
•
Hot Cue Mode: Each pad assigns a Hot Cue Point or returns the track to that Hot
Cue Point. When a pad is unlit, you can assign a Hot Cue Point by pressing it at the
desired point in your track. Once it is assigned, the pad will light. Press and hold Shift
and then press a pad to delete its assigned Hot Cue Point.
•
Hot Cue Auto-Loop Mode: Each pad assigns a Hot Cue Point or returns the track to
that Hot Cue Point, but in both cases, it also creates an Auto-Loop at that point. The
Auto-Loop's length is set in the software, but you can decrease or increase it with the
Parameter < or Parameter > button.
Pad 2
Pad 1
Pad 5 Pad 6
Hot Cue 2
Hot Cue 1
Hot Cue 5 Hot Cue 6
Pad 3 Pad 4
Pad 7 Pad 8
Hot Cue 3 Hot Cue 4
Hot Cue 7 Hot Cue 8
®
, so they are
9