GE GTH20JBBABB Manuel D'utilisation Et D'installation page 19

TRANSFER FRESH FOOD
7
HANDLE TO THE RIGHT
Reinstalling the handle: Attach the handle to the
right side of the door.
Stainless steel handle:
A
Attach the handle
to the fastener and
tighten with the 3/32"
Allen wrench
(supplied).
B
Line up the handle
with the screw holes in
the top of the door and
tighten the screws.
Plastic handle:
A
Line up the handle
with the screw holes in
the top and in the middle
of the door and tighten
the screws.
B
Attach the handle plug
TRANSFER FREEZER DOOR
8
HANDLE TO THE RIGHT
Stainless steel handle:
A
A
Remove the two screws holding the handle to the
bottom of the door. Loosen the set screw with the 3/32"
Allen wrench (supplied) and remove the handle.
B
B
Remove the handle fastener with the 3/16" Allen
wrench.
C
C
Transfer the fastener to the right side and move the
GE badge to the left side of the door. Use the new badge
(supplied), remove the paper covering on the adhesive
backing prior to attaching the badge to the door.
B
Fastener
A
Installation Instructions
(CONT.)
B
A
A
B
Handle plug
C
TRANSFER FREEZER DOOR
8
HANDLE TO THE RIGHT
Plastic handle:
A
Remove the two screws
holding the handle to the
bottom of the door.
B
Remove the handle plug
by carefully prying under
the edge with a putty knife.
Remove the exposed screw
holding the handle.
C
Transfer the GE badge
to the opposite side.
Use the new badge (supplied),
remove the paper covering on
the adhesive backing prior to
attaching the badge to the door.
Reinstalling the handle:
Attach the handle to the
right side of the door.
Stainless steel handle:
A
Attach the handle to
the fastener and tighten
with the 3/32" Allen
wrench (supplied).
B
Line up the handle
with the screw holes in
the bottom of the door
and tighten the screws.
Plastic handle:
A
Line up the handle
with the screw holes in
the bottom and in the
top of the door and tighten
the screws.
B
Attach the handle plug
(CONT.)
Handle plug
B
Badge
C
A
A
B
Handle plug
B
A
19