GE GTH20JBBABB Manuel D'utilisation Et D'installation page 18

REVERSING THE DOOR SWING
TRANSFER CENTER HINGE
5
BRACKET TO THE LEFT
Using a torx T-20 driver remove the center hinge
bracket by removing the three screws.
NOTE: Keep these screws with the hinge bracket.
They are long screws and will be used when installing
the hinge on the other side.
You will need to remove the color-matched cap from
the screw head before you can remove the screw.
Use the edge of a thin flat blade to gently pry the
caps off the screw heads. (A putty knife works well
for this.) Cover the blade with tape to prevent
scratching the paint.
Remove the mullion cover from the left side using
the thin flat blade. Assemble it to the right side.
Remove the screw from the center left side of the
cabinet. Screw it into the holes on the right side.
Replace the cap by snapping it over the screw with
your finger.
Place the center hinge bracket over the holes at
the center left side of the cabinet. Insert and
tighten the three long screws.
Mullion Cover
TRANSFER DOOR STOPS
6
On each door, remove the door stop on the right side
of the bottom of the door by removing the two screws.
Install the door stop on the left side.
Bottom of Door
(Right Side)
18
Installation Instructions
Screw Cap
Bottom of Door
(Left Side)
(CONT.)
TRANSFER FRESHFOOD
7
DOOR HANDLE TO THE RIGHT
Stainless steel handle:
A
Remove the two screws
holding the handle
to the top of the door.
Loosen the set screw
with the 3/32" Allen
wrench (supplied) and
remove the handle.
B
Remove the handle
fastener with the 3/16"
Allen wrench.
C
Transfer the fastener
to the right side and
move the plug button to
the left side of the door.
Plastic handle:
A
Remove the two
screws holding the
handle to the top of
the door.
B
Remove the handle
plug by carefully
prying under the edge
with a putty knife.
Remove the exposed
screw holding the handle.
C
Transfer the door
plug button to the
opposite side.
After removing the handle: Move the small plug
buttons from the top right side of the door top and
insert them into the holes on the opposite side.
Move the large plug button from the left edge of the
door and insert it into the hole on the opposite side.
Plug Button
A
C
Fastener
Plug
B
Button
A
C
Plug
B
Button
Handle
Plug
Small Plug
Buttons