Mains Connection; Operation Adjustment; General Instructions For Use - stayer CD125K Instructions D'emploi

motor body, so that the diamond cutting discs do not
reach to touch the workpiece.
Otherwise, the diamond cutting discs can touch the
workpiece, resulting in possible loss of control over the
power tool when switching on.
For the implementation of the machine press the unlock
button switch 23 and then press the trigger on / off 1.
To switch off the power tool, release the On/Off switch 1.
Never set down a coasting machine on the
chaser rollers 3, but always aside, so that the
diamond cutting discs can rotate freely and do
not face toward your body.
Check the diamond cutting discs before use. The
diamond cutting disc(s) must be mounted
properly and be able to rotate freely. Carry out a
test run for at least one minute without any load. Do not
use diamond cutting discs that are damaged, outof-
balance, or vibrate. Damaged diamond cutting discs can
rupture and lead to injuries.
4.2

Mains connection

Reduced starting current
The electronic reduced starting current limits the power
consumption when switching the tool on and enables
operation from a 13 ampere fuse.

4.3 Operation adjustment

Pre-selecting the Cutting Depth
The cutting depth may only be pre-selected when
the machine is switched off.
Loosen clamping lever 9 and adjust the desired cutting
depth according to the cutting-depth scale 2. Afterwards,
tighten clamping lever 9 again.

4.4 General instructions for use

Please observe the following notes in order to reduce the
dust emissions occurring while working.
– Use only the combinations of wall chaser and dust-
category M vacuum cleaner recommended by
Other combinations can lead to insufficient dust
collection and separation.
– Observe the operating instructions of the vacuum cleaner
for maintenance and cleaning of the vacuum cleaner,
including the filter. Empty dust collection containers
immediately once full. Clean the filters of the vacuum
cleaner regularly and always insert the filters completely
into the vacuum cleaner.
– Only use vacuum hoses as intended for by
not manipulate the vacuum hose. When rocks or chunks
of stone/masonry are drawn into the vacuum hose,
cease work and clean the vacuum hose immediately.
Prevent the vacuum hose from being bent or creased.
ENGLISH
22
– Use the wall chaser only according to its intended use.
– Only use tools that are in perfect condition. Decrease in
work progress is noticeable whilst using worn tools.
– Observe the general requirements for construction sites.
– Provide for good ventilation.
– Ensure that the working range/area is free of obstructions.
For longer slots, the vacuum cleaner must be guided
along in time, without obstructions in the path.
– Wear hearing protection, protective goggles, dust mask
and gloves as required. As dust mask, use at least a
particle-filtering class FFP 2 half-mask.
– Use a suitable vacuum cleaner for cleaning the
workplace. Prevent settled dust from being swirled up by
sweeping.
Exercise caution when cutting slots in structural
walls.
Do not strain the machine so heavily that it comes
to a standstill.
Clamp the workpiece if it does not remain
stationary due to its own weight.
The machine may only be used for dry cutting.
Always guide the machine with both handles. Do
not guide or carry the machine by the elbow.
Adjust the cutting depth.
To compensate inaccuracies that occur when breaking
away the fin, the cutting depth must be set approx. 3 mm
deeper than the requested slot depth.
STAYER .
– Place the power tool in such a manner on both rear chaser
rollers 3, that the diamond cutting discs do not touch the
workpiece.
– Switch the machine on and slowly plunge into the
material.
– Guide the machine with both handles, applying moderate
STAYER . Do
feed, suited to the material being worked.
– The machine must always work in an upgrinding motion.
Otherwise, the danger exists of it being pushed
uncontrolled out of the cut.
22