Num'axes CANICOM 200 Guide D'utilisation page 25

Maintenance
Troubleshooting
- Avoid cleaning the unit with volatile liquids such as solvents or cleaning fluids. Use a soft cloth and
neutral detergent.
- In order to maintain water tightness, we recommend the replacement of the seal located in the receiver
collar every year.
Should your CANICOM 200 stop working or develop a fault, first read this user's guide over, then check
the batteries and replace them if necessary and retry. Also check that you are using the product correctly.
If you encounter any problem, re-code the collar with the remote control (ref. coding procedure).
Re-initialise the system by removing the battery from its housing, then with a metallic tool (e.g.
screwdriver, scissors) touch each of the 2 battery contacts for 2 seconds approximately (ref. Diagram 7).
Insert the battery again: One beep is emitted, indicating the battery is in correct position.
Restart your CANICOM using the remote control.
If the problem persists, contact your distributor or check out on www.numaxes.com.
You can also contact NUM'AXES at +33.2.38.69.96.27 or by Email export@numaxes.com.
Depending on the extent of the malfunction, you may have to return your product for service and repair.
For all repairs, please supply the following:
- the complete product
- the proof of purchase (invoice or sales receipt)
If you omit one of these items, the After Sales Service will have to invoice you for any repair costs
incurred.
Diagram 7
Reset: connect
the 2 supports of
the battery
Gb - 25