PLYMOVENT FUA-1300 Manuel Opérateur page 7

A (x 4)
Fig. 4.1 Installing the fan on an MB-FUA-S1/S2
4.2.3 Installing the fan on an MB-FUA-C1/C2
For use on an extractor (UK or FlexMax) or use with vehicle
exhaust extraction systems.
To install the fan on an MB-FUA-C1/C2 bracket, proceed as
follows:
Fig. 4.2
• Use the mounting holes (A) and suitable hardware (not
supplied, material depending on wall type) to install the
bracket on the wall.
• Position the fan on the bracket.
• Tighten the bolts (B).
A
Fig. 4.2 Installing the fan on an MB-FUA-C1/C2
4.2.4 Changing the outlet position
The fan outlet can be positioned in various directions (see Fig.
4.3).
0000100435/060614/A FUA-1300/1800/2100/3000/4700 (50Hz)
B (x 4)
Fig. 4.3 Variable outlet position
To change the outlet position of the fan, proceed as follows:
Fig. 4.4
• Define the desired outlet position.
• If necessary, loosen the motor plate by unscrewing the
bolts (A).
• Turn the motor in the desired position.
• Tighten the bolts of the motor plate.
A (x 6)
B (x 4)
Fig. 4.4
4.2.5
The FUA-1300/1800/2100 can be used on the KUA or LM-2
extraction arm. In that case, no additional bracket is needed.
The necessary hardware is delivered with the arm.
To install the fan directly on the arm, proceed as follows.
Changing the outlet position
Installing the fan directly on an arm
EN - 6