Krüger & Matz KMPM3 Mode D'emploi page 11

Owner's manual
Play/ pause music
Redial last number
PAIRING
1. With the earphones turned off, press and hold the multifunctional
button on both earphones simultaneously for about 6 seconds.
The earphones will turn on, pair with each other and enter
Bluetooth pairing mode. Blue and red LED on right earphone
flash.
2. Enable Bluetooth function on an external device and search
for new Bluetooth devices.
3. Select and connect with this device (KM M3).
4. After successful pairing, blue LED on the right earphone flashes
blue every 6 seconds.
Notes:
• Every time the earphones are switched on, they will connect to
last connected device automatically. Please note, your device
must be on with Bluetooth function turned on.
• The earphones may be used in mono mode. You can connect
the right earphone with the external device. To do this, please
follow the instructions given above.
CHARGING
1. Connect each of DC plugs of the USB charging cable to each of
the charging sockets on both earphones.
2. Connect the USB interface to the compatible PC USB port.
3. During charging, red LED is on.
4. When the battery is fully charged, red LED goes off.
5. Disconnect the charging cable from the power source and the
earphones.
Press the multifunctional button
Press the multifunctional button twice
EN
11