Spanning Instellen; General Instructions; Cleaning And Maintenance; Important Guidelines - Princess 505104 Mode D'emploi

LET OP:
Indien deze haardroger in de badkamer gebruikt wordt, raden wij u aan onmiddellijk na gebruik de stekker
uit het stopcontact te trekken. Ditvanwege het gevaar door de nabijheid van water indien men de haardroger
zou laten vallen. Voor een aanvullende veiligheid dient de elektrische installatie van de badkamer beschermd
te zijn door een aardlekschakelaar met een aanspreekstroom van 30 mA. Raadpleeg bij twijfel uw installateur.
BLAASMOND
Het ideale hulpmiddel om de haren snel en luchtig te drogen. Met de blaasmond is het mogelijk bepaalde
lokken nauwkeurig te drogen en accenten te leggen waar u wilt. Dit kan met warme of koude lucht.

SPANNING INSTELLEN

Dit apparaat kan worden ingesteld op 120 of 230 volt. Voordat u de stekker in het stopcontact steekt, moet
u controleren of de schakelaar op de juiste netspanning ingesteld staat. Indien nodig de schakelaar omzetten.
PRINCESS TRAVEL HAIRDRYER
BEFORE USING
Read these instructions carefully before use and keep them for later reference. Make sure that the voltage
corresponds with that of the appliance. Do not use the hairdryer near a sink filled with water, a bathtub,
shower etc. Never try to pick up equipment that has fallen into water, but pull the plug out of the socket
first. Use the hairdryer with dry hands only.

GENERAL INSTRUCTIONS

This travel hairdryer has an elegant design in polished stainless steel and is easily portable thanks to the
retractable handle. Complete with 2 speeds / temperature settings.
To give styled hair volume, or to give shape to the hair, use the round brush when drying. If you want
straight, smooth hair, use a flat brush. To give your hair a root lift, first dry it in the opposite direction.
Curling your hair with your fingers is the best method to add volume and shape to naturally curly or
permed hair and also for thicker hair. Take a wet lock of hair in your hand and massage it while you let a
stream of hot air flow through your fingers. Keep holding the lock until it cools. When all your hair is dry,
shake out the curls and run your fingers through it. Caution: holding the hairdryer too close to your hair,
or for too long, will overheat or dry out your hair. By using a low temperature and speed, you will quickly
and safely achieve the best results.

CLEANING AND MAINTENANCE

Always pull the plug out of the socket first!
Clean the outside of your hairdryer with a damp cloth. Never immerse it in water or any other liquid!
Ensure that the air inlet at the back is not blocked with hairs and fluff. If required, clean out the grille
with a stiff brush or tweezers. Make sure the grille does not become blocked while drying.

IMPORTANT GUIDELINES

- When using rollers, etc. in your hair, we recommend that you be very careful with any pins and clips.
- Take care that they cannot enter the ventilation and air openings in the dryer!
- After use, always pull the plug from the socket.
- Never direct a (hot) airflow at your eyes or sensitive parts of the face.
- Never use any spray cans near the hairdryer when it is switched on.
- Do not wind the lead wire too tightly around the hairdryer, this will prevent damage to the lead.
- Use only the original accessories supplied.
- Allow the hairdryer to cool down before putting it away.
- Do not lay a switched on and/or hot hairdryer on soft furnishings, such as a bed, cushion,
etc. This will prevent over-heating.
- Instruct young children about the dangers and safety rules concerning electrical equipment.
- Never let young children use electrical equipment without supervision.
- Do not attempt to lubricate this hairdryer. Repairs and service should always be carried
out by an expert Service Department. Do not use the appliance if it is damaged; send it
to our service department.
- This hairdryer is intended for normal household use only.
- If damaged, the lead on this hairdryer can only be replaced using the special tools in our
service department. If the lead is damaged, the hairdryer must be sent for repair to our
service department.
ART. 505104 / 505108
5