Monitor Relay Programming - Varian Turbo-V 300HT Notice De Mode D'emploi

Enter the selection
•
CURRENT pushbutton, and the display shows:
F R O N T / R E M O T E
S E L E C T I O N : X X X X X X
where: XXXXXX = means the word FRONT or
REMOTE depending on the last selection.
The controller is factory-set for FRONT panel
operation.
Choose the desired selection by pressing the
•
CYCLE pushbutton.
F R O N T / R E M O T E
S E L E C T I O N :
Confirm the selection by pressing the PUMP
•
CURRENT pushbutton.
In this way you enter into an operating phase
•
named "Monitor Relay Programming" described in
the following paragraph.
by pressing the PUMP
F R O N T

Monitor Relay Programming

The display shows:
•
S P E E D
S E L E C T
where: XXKRPM = is the switch point of relay R1 at
the preset turbopump speed, adjustable from 00 to
99 KRPM.
The speed threshold will condition the R1 and R2
operation (see the following cycle diagram) and it is
factory-set to 53 KRPM.
Press the CYCLE NUMBER pushbutton to select
•
the first number.
S P E E D
S E L E C T
65
TECHNICAL INFORMATION
T H R E S H O L D
I O N : X X K R P M
T H R E S H O L D
I O N : X X K R P M
87-900-884-01 (C)