Connection D - Controller-To-Pump Connection - Varian Turbo-V 300HT Notice De Mode D'emploi

Connection D - Controller-to-Pump Connection

To connect the controller to the pump, an appropriate
interconnection cable must be prepared to connect the
P10 connector of the controller with the pump
connector.
The following figure shows the pump output connector
configuration where pins:
− A-F = pump temperature sensor
− B-C-D = 80 Vac 3-phase output to pump motor
stator
− E = ground.
P10
CONTROLLER
PHASE R
PHASE S
PHASE T
PUMP TEMP . SENSOR
PUMP TEMP . SENSOR
GND
SCREEN
Controller to pump cable
55
TECHNICAL INFORMATION
A
TURBO-V
B
F
PUMP
CONNECTOR
C
E
D
PUMP
87-900-884-01 (C)