Using The Heater - Perel FT5130 Mode D'emploi

Before putting the device into operation, check for gas leaks at the screwcaps using a detection
spray or soapy water. Retighten them if necessary.
4.3

Using the Heater

Never aim the heater at the cylinder. The hose must always trail at the rear of the heater.
Never separate a switched-on heater from the gas cylinder.
1. Make sure the heater has been assembled correctly.
2. Open the regulator to feed the gas.
3. Turn the control knob to position 1 and hold pressed. Ignite the pilot light with a match.
Keep pressing the control knob for another 10 seconds.
4. Turn the control knob to position 2 to adjust the flame.
5. To turn off the heater, interrupt the gas feeding by closing the regulator. Once the flame
has died out, turn the control knob back to position 1.
4.4 Changing a Gas Cylinder
Only replace the gas cylinder in a non-flammable and non-smoking environment.
1. Close the valve of the gas cylinder.
2. Unscrew the regulator from the valve of the cylinder. Remove the device. Take the empty
cylinder away from the heater.
3. Make sure the sealing of the pressure controller is still place.
4. Install the heater onto a new gas cylinder. To do so, follow the instructions described
above.
4.5 Storage
1. Disconnect the heater from the cylinder. Refer to the instructions described above.
2. Store the cylinder in a well-ventilated area, preferably in an outhouse, away from any
combustible materials.
3. Store the heater in its original package and keep in a dry and dust-free environment.
V. 04 – 29/05/2018
start/position 1 (high)
FT5130
4
position 2 (low)
©Velleman nv