General Guidelines - Perel FT5130 Mode D'emploi

 This device requires a flexible gas hose and gas regulator. Check with your gas supplier.
Hose: EN 16463-1 class 2/class 3 compliant hose (length < 2 m); regulator: G3:28-
30 mbar, G31: 37 mbar.
 Any cleaning, maintenance or repair activity involving a dangerous component (e.g.
replacement of a damaged power cable, repair of the burner) must be done by the
manufacturer, its after-sales service or a qualified technician in order to avoid risks.
 Any maintenance, replace or repair activity involving a dangerous component must be done
by the manufacturer, its after-sales service or a qualified technician in order to avoid risks.
A list of spare parts can be obtained from the manufacturer.
 The heater must only be used when an adequate air exchange rate can be guaranteed.
This device must therefore be used in the open air or in a well-ventilated room only. Install
the device following all local regulations, included those with respect to technical standards
and the regulations concerning the prevention of accidents and fires.
 This appliance is only destined for following countries: Belgium (BE), Spain (ES), France
(FR), Great-Britain (GB), Ireland (IE), Portugal (PT).
3.

General Guidelines

 Refer to the Velleman
 All modifications of the device are forbidden for safety reasons. Damage caused by user
modifications to the device is not covered by the warranty.
 Only use the device for its intended purpose. Using the device in an unauthorised way will
void the warranty.
 Damage caused by disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
 Nor Velleman nv nor its dealers can be held responsible for any damage (extraordinary,
incidental or indirect) – of any nature (financial, physical...) arising from the possession,
use or failure of this product.
 Keep this manual for future reference.
4. Operation
4.1 Installation
1. Make sure all components are standing safely.
2. Use a clamping screw to fix the holder on the bottle.
3. Screw the pressure controller and the gas hose on the valve of the gas cylinder.
4. Use the butterfly nut and the chrysanthemum gasket to put the heater to the required
position. Fix it on the stand.
5. Screw the other end of the gas hose to the safety valve. Make sure all the screws are tight.
4.2 Connection to the Gas Cylinder
Keep the gas cylinder and heater away from any open flames.
Before connecting the appliance, check the installation regulations in force in the country
where the appliance is to be used.
1. Use an approved regulator and a gas hose with a length between 40 cm and 50 cm. Avoid
twisting the hose.
2. Slowly turn on the regulator and check if there are no gas leaks. To do so, brush some
soapy water on all connections.
V. 04 – 29/05/2018
FT5130
® Service and Quality Warranty on the last pages of this manual.
3 ©Velleman nv