Extinguishing The Flame; Cleaning And Maintenance - Perel TC84100N Mode D'emploi

5.2 Igniting the Heater
When igniting the heater for the first time, wait about 10 minutes until the wick is
soaked with fuel. If you ignite the wick when it is not soaked you will burn it and cause
1. Lift the wick by turning the wick adjusting handle to the right.
2. Lift the chimney slightly from the burner.
3. Light the wick with a match and reposition the chimney properly on the burner.
5.3 Adjusting the Flame
If the wire net on top of the chimney turns red hot, the
combustion is correct.
If the flames flare up over the wire net, the wick is too high.
Lower the wick.
If the wire net stays dark, the wick or fuel level is too low.
Raise the wick or refill with fuel.
5.4

Extinguishing the Flame

To extinguish the heater, turn the wick adjusting handle to the right. The flame will stop after 3 to 5 minutes.
Turn the wick adjusting handle gently. Too excessive a handling can sometimes cause a blow flame. Take care
the flame is completely extinct when you fill or replace the heater. Be sure the flame is completely out when
the heater is left alone.
6.

Cleaning and Maintenance

WARNING! Make sure to empty the tank before transporting or shipping the device.
6.1 Storing
Disassemble and clean the kerosene heater before storing. Empty the tank, turn the tank upside down and
clean with cloth imbibed with a lighting kerosene.
The wick should be kept apart from the wick holder and fuel tank.
Store the heater in a dry and well-ventilated place.
In the unlikely event of technical problems or should you need spare parts, please contact your dealer.
V. 01 – 22/05/2017
TC84100N
WARNING
heavy smoke. The warranty will not be valid.
4 ©Velleman nv