Siemens LC 759 Série Mode D'emploi page 22

Operating procedure
Switching off
With fan run-on started from manual
mode:
Press the button.
The fan runs at the setting last selected.
The dot on the display flashes.
After 10 minutes the fan switches off and
the displays go out.
With fan run-on started from automatic
mode:
Press the button.
Fan run-on does not start until the
automatic function has switched the fan
|
back to Setting .
The dot on the display flashes.
After 10 minutes the fan switches off and
the displays go out.
Without fan run-on:
L
Press the button.
Light
The light can be used at any time, even
when the appliance has been switched
off.
Switching on/off:
a
Press the button.
22
Special functions
Adjusting the sensitivity of the sensor
control:
1. Press and hold down the automatic
button.
2. To display the current sensitivity, press
+ –
the or button.
3. You can now change the sensitivity of
the sensor control by pressing the
–
button.
@
Factory setting:
{
Lowest setting:
Ö
Highest setting:
Switching on the light automatically, e.g.
via a timer:
Fan and light must be switched off.
Switching on:
Simultaneously press the
buttons.
After approx. 3 seconds the light
switches on to acknowledge the setting.
Switching off:
Repeat the process with the light switched
on.
After approx. 3 seconds the light
switches off to acknowledge the setting.
+
or
.
.
.
a and
L