Kenwood CMOS-230 Mode D'emploi page 5

10
After adjusting the camera angle, tighten the
retaining screws fi rmly.
Inspect the retaining screws at times. If they are loose,
tighten them fi rmly.
11
Fix the camera fi rmly in position.
Peel off the paper liner from the double-side adhesive tape
on the camera bracket and attach it. After attaching, push the
camera bracket with your fi nger to ensure close adhesion.
Do not touch the adhesive surface with your hand or peel and
reattach an attached tape, as these will degrade the adhesive
force and may cause the camera bracket to be detached. If
required, secure the bracket on the vehicle body using the
camera bracket clamping screw.
The camera bracket has two holes for the screw. Select one of
them to fi t the position of the attachment.
Camera bracket clamping screw
(M3 x 8mm)
5
|
ENGLISH