General Warnings - Haverland RC-A Série Manuel D'installation Et Utilisation

IMPORTANT!
WE THANK YOU FOR PURCHASING A HAVERLAND THERMAL TRANSMITTER.
PLEASE READ THESE INSTRUCTIONS BEFORE STARTING THIS APPLIANCE.
THESE INSTRUCTIONS SHOULD BE KEPT FOR FUTURE REFERENCE AND SHOULD BE
GIVEN TO ANY NEW USER.
BEFORE CONNECTING THE APPLIANCE MAKE SURE THAT IT'S VOLTAGE (230 V – 50 HZ) IS
THE SAME VOLTAGE OF THE POWER SUPPLY WHERE IT IS GOING TO BE CONNECTED.
THE APPLIANCE SHOULD NOT BE USED IN PRESENCE OF GASES, EXPLOSIVES OR
INFLAMMABLE OBJECTS.

GENERAL WARNINGS

This thermal transmitter is an appliance to be fixed to the wall. Please read the explicatory
instructions for its assemblage.
This transmitter has been filled with determined quantity of a special thermal fluide. For this reason
the necessary reparations that need the opening of the deposit or presence of any kind of escape
should be undertaken by the manufacturer or by its Technical Assistance Service.
Introduce and take out the plug when the switch is in the OFF position. Never pull the wire.
Do not leave the connection wire in contact with the appliance while it is On.
During its functioning, one must be careful to maintain the appliance far from combustible material
such as curtains, carpets, furnitures, etc.
DO NOT COVER THE APPLIANCE. DO NOT USE IT TO DRY CLOTHES. If it is covered there is
an overheating risk.
If the power supply cable is damaged, it should be substituted by another one provided by the
manufacturer or its Technical Assistance Service.
If the appliance is going to be installed in the bathroom, it should be put in such a way that nobody
in the bathtub or shower should be able to touch it.
The appliance should not be located under or in front of a power supply socket.
At the moment of getting rid of these transmitters, the established rules for their treatment and
recycling should be kept into account (thermal fluide).
The installation should be undertaken according to the correct rules regarding the electric
installation.
All the models come with a safety thermostat. This will disconnect the appliance if it gets overheated
for any reason.
The appliance should have a ground connection.
The appliance should be installed in such a way that the power supply plug should always be
accessible.
This transmitter should not be fitted in. Please respect the safety distance.
The guarantee of the appliance will not cover any damage caused because of not reading and
following carefully these instructions
.
14