LENCO DIR-270WD Mode D'emploi page 9

1. Select YES if you want to continue and connect to your WIFI network using the standard
method. Press the Navigation (8) wheel to confirm. Continue reading 'network
configuration' option 1.
2. Select YES(WPS) if you would like to set up with the WPS (WIFI PROTECTED SETUP) function
of your router (please verify with your router's manual if it's available). Press the
Navigation (8) wheel to confirm. Continue reading 'network configuration' option 2.
3. Select NO and Press the Navigation (8) wheelto confirmif you want to skip the Wireless
network setup. You can configure it later in the setup menu.
1. Standard network configuration
After selecting this option the DIR-270 will scan for available WIFI networks.
The display will show the networks it found.
Select your WIFI network by turning the Navigation/OK (8) wheel and confirm by pressing the
Navigation/OK (8) wheel.
If your selected WIFI network requires a password, you can enter it in the next screen.
Network configuration
9