Blender - SEVERIN SM 3714 Mode D'emploi

GB

Blender

Dear Customer,
Before using the appliance, please read the
following instructions carefully and keep this
manual for future reference. The appliance
must only be used by persons familiar with
these instructions.
Connection to the mains supply
Make sure that the supply voltage
corresponds with the voltage marked on the
rating label of the appliance. This product
complies with all binding CE labelling
directives.
Familiarisation
1. Feeder opening stopper
2. Blender jug
3. Motor housing
4. Push switch
5. Control switch
6. Safety switch
7. Feeder opening
8. Lid
9. Contact pin
10. Power cord with plug
11. Rating label
12. Blade
13. Drive shaft coupling
Important safety instructions
∙ In order to avoid hazards, and to
comply with safety requirements,
repairs to this electrical appliance or
its power cord must be carried out by
our customer service. If repairs are
8
needed, please send the appliance
to our customer service department
(see appendix).
∙ Before cleaning the appliance,
ensure it is disconnected from the
power supply and has cooled down
completely.
∙ To avoid the risk of electric shock, do
not clean the appliance with liquids
or immerse it.
∙ Clean the blender jug in hot soapy
water.
∙ For detailed information on cleaning
the appliance, please refer to the
section Cleaning and care.
∙ Caution: Do not fi ll the jug with hot
liquid.
∙ Care is required when pouring hot
liquids into the blender jug in case a
jet of vapour should escape from the
appliance.
∙ Caution: Any misuse can cause
severe personal injury.
∙ Caution: The blender blades are
extremely sharp. To prevent injury,
take special care when cleaning or
emptying the jug.
∙ Always remove the plug from the wall