SEVERIN SM 3714 Mode D'emploi page 10

Before using for the fi rst time
Before the appliance is used for the fi rst
time, the blender jug and the lid should
be thoroughly cleaned as described in the
section Cleaning and care.
Switch settings
The following settings can be selected:
P The appliance remains switched on as
long as the switch is depressed
0 The appliance is switched off
1 Low power
2 Medium power
3 Maximum power
Short-term operation
The appliance is designed to process
average domestic quantities of food; it
can be operated without interruption for
a maximum of 45 seconds, after which it
should be allowed to cool down for about a
minute.
Safety switch
A special safety switch in the motor housing
ensures that the appliance can only be
operated once the blender jug and lid are
properly locked in position.
Before removing the blender jug, make
sure that the control switch is in position 0.
This also applies when fi tting the blender
jug to the motor housing. If the switch is
not in its off-position (0), the motor will start
immediately.
Operation
∙ Fit the blender jug to the motor housing
with its handle on the right and lock it by
turning anti-clockwise into the operation
position.
10
∙ Put the liquid ingredients into the blender
jug. The jug has a maximum capacity of
1500 ml. To avoid possible foaming or
spilling when processing foamable or thin
liquids such as milk, do not fi ll the jug over
the 1000 ml mark.
∙ Put the lid on and lock it by turning
anti-clockwise. To add ingredients during
operation, the stopper in the centre of the
lid can be removed by turning it in an anti-
clockwise direction and then lifting it off.
Do not put any objects into the blender
jug while the appliance is operating.
∙ Insert the plug into the wall outlet and use
the control switch to select the required
power setting. Depending on the food to
be processed, the appliance may also be
operated for short periods of time with the
pulse setting 'P'. Do not operate when the
blender jug is empty.
∙ After using the blender, switch off and
remove the plug from the wall socket.
Wait until the motor has come to a
complete standstill before removing the
blender jug. To remove the jug and the
lid, turn them in the opposite direction
from that described in the assembly
instructions.
Information for testing institutes:
The following recipe may be used:
Mix 600 g soaked carrots and 900 g water
for 45 seconds.
Cleaning and care
∙ Always remove the plug from the wall
socket before cleaning the appliance.
∙ To avoid the risk of electric shock, do not
clean the motor housing or the power
cord with liquids and do not immerse
them in water. The motor housing may be