Dear Customer
Before using the appliance, the user must
read the following instructions carefully.
Familiarisation
1.
Power cord with plug
2.
Hanging loop
3.
Operating button I
4.
Operating button II
5.
Drive unit
6.
Blender unit
7.
Blade unit
8.
Blender jar
9.
Whisk attachment
Connection to the mains supply
Make sure that the supply voltage corresponds
with the voltage marked on the rating label of
the blender.Th is product complies with all
binding CE labelling directives.
Important safety instructions
Before the appliance is used, the main
body as well as any attachment fi tted
should be checked thoroughly for any
defects. Should the appliance, for instance,
have been dropped onto a hard surface, it
must not be used any longer: even invisible
damage may have adverse eff ects on the
operational safety of the appliance.
Th e power cord should be regularly
examined for any signs of damage. In the
event of such damage being found, the
appliance must no longer be used.
Do not operate the appliance if excessive
force has been used to pull the power
cord. Damage cannot always be detected
from the outside; the entire unit should
therefore be checked by a qualifi ed
technician before it is used again.
Th is appliance is not intended for use
by any person (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
Hand Blender
knowledge, unless they have been given
supervision or instruction concerning
the use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure
that they do not play with the appliance.
Caution: Keep any packaging materials
well away from children, as they are
a potential source of danger e.g. from
suff ocation.
Great care is necessary when using this
appliance, especially near children. Do
not leave the appliance unattended while
connected. Always remove the plug from
the wall socket, even if you leave the room
only for a short while.
Ensure that children do not operate the
appliance without supervision.
Do not allow the unit or its power cord to
touch hot surfaces or to come into contact
with any heat sources.
Always switch the appliance off and
remove the plug from the wall socket
before fi tting, removing or cleaning the
blender unit or the whisk attachment.
Th e blade is extremely sharp. To prevent
injuries, take special care when handling
these parts.
Aft er switching off , always wait until the
motor has come to a complete standstill.
Do not touch any moving parts.
Always remove the plug from the wall
socket aft er use, and also
-
in case of any malfunction
-
during cleaning of the appliance.
During operation, the unit should be
placed on a scratch-resistant surface.
No responsibility is accepted if damage
results from improper use, or if these
instructions are not complied with.
Th is appliance is intended for domestic use
only and not for commercial applications.
In order to comply with safety regulations
and to avoid hazards, repairs of electrical
appliances must be carried out by qualifi ed
personnel, including the replacement
of the power cord. If repairs are needed,
please send the appliance to one of our
7