Maintenance And Care - HumanTechnik time flash A-3128-0 Mode D'emploi

Face illumination (back light)
Touching the Light/Snooze Alarm sig-
nal cancel switch will light the face.
Switching on the clock face illumi-
nation
Press the Light/Snooze button to
switch on the clock face illumination
for about 4 seconds.
Special aspects
• The alarm signal is repeated after 4
minutes (autosnooze) unless you
press the Light/Snooze button or
the alarm ON/OFF button.
• The quartz mechanism of the alarm
clock has a backup power supply.
The clock will continue to operate
for about 2 hours if there is a power
failure. The alarm function and the
illumination are deactivated during
this period.
• The clock face illumination is also
activated when the alarm is triggered.
• In addition to the green marking of
the Alarm ON/OFF switch, the
snooze button is also illuminated
when the alarm is triggered.
• You can select between two diffe-
rent alarm types. The alarm type is
altered as described below:
Switch off the alarm.
Press and hold the snooze button
for 3 seconds.
Switch the alarm back on.
The Snooze button flashes to indi-
cate that the second alarm type
has been selected.
8 English

Maintenance and care

The time fl sh does not require any
maintenance. If the unit does beco-
me dirty, simply wipe it clean with a
soft, damp cloth. Never use spirits,
thinners or other organic solvents. Do
not set up the unit where it will be
exposed to full sunlight for long peri-
ods. In addition it must be protected
against excessive heat, moisture and
severe mechanical shock.
Note: This product is not protected
against splash water. Do not place
any containers filled with water, such
as flower vases, or anything with an
open flame, such as a lit candle, on
or near the product.