EXPERT MENU
¾
To access the appliances' advanced functions, press the buttons
and
+ for a few seconds. Then enter the password "3106" with the + and -
buttons, confirming each digit with
.
The screen will display:
OFSt allows you to adjust your setpoint temperature in relation to
the temperature recorded in the room if you notice a difference. The
calibration value is between -3° C below and +3° C above the set
temperature. Adjust the temperature with the + and - buttons then
confirm with
.
Example: your radiator displays a temperature of 20° C. The temperature
displayed on your thermometer is 22° C => choose the calibration value -2° C.
PuiS is used to select settings based on the power (not applicable to this
model of HMI).
StC is used to record a maximum setpoint temperature which cannot
be exceeded. (between 19° C and 30° C; default temperature setting at
30° C).
b300 is used to test the appliance's capacity to heat at full power for 300
seconds.
34