Thermor SSC NF 3 Etoiles Oeil Notice D'utilisation page 36

Problem encounte-
red
The surface of the
appliance
is very hot.
Dirty marks
can be seen on
the walls around
the appliance.
The
top and bottom
elements
are cooler
that the rest of
appliance
The appliance does
not follow
internal
programming
orders.
The appliance does
not follow
external
programming
orders.
If you have not found a solution for your problem, contact your distributor/installer with the
references of your appliance. They can be found on the side of the appliance.
Measure the room temperature.
The Commercial code (C) and the appliance's Serial number (E) given by the manufacturer.
A Standards, Quality labels
B Trademark
C Commercial Code
D Manufacturing reference
E Serial number
F Manufacturer number
Checks to perform
It is normal for the appliance to be hot when operating, with a
maximum surface temperature within the limits of the
NF Electrical Performance standard. If, however, you think that
your appliance is still too hot, check that its power rating
is suitable for the volume of your room (we recommend
100 W/m 2 for a ceiling height of 2.50 m or 40W/m 3)
and ensure it is not located in a draft which could
interfere with its heat control.
You may observe dirt on the appliance's
air outlets or surrounding walls if it operates in a polluted
environment. This phenomenon is related to
the poor quality of the ambient air (cigarette smoke, candles, incense,
fireplace ...). If this is the case, we advise that the room is correctly
aired
(ventilation, air inlet, etc.).
The top elements are not completely
filled to allow for the expansion of the thermodynamic fluid. They
are heated uniquely by conduction.
The bottom elements channel the return flow of the fluid
which has transmitted its heat.
Check that the date and time are set.
Check that the appliance is in Active Programming Mode.
Make sure that you are using the programming unit correctly
(see control unit user manual).
Check that the device is in Pilot Wire Mode
36
.