Power Supply; Instruction Manual - Makita LW1400 Manuel D'instructions

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Wheel diameter
Hole diameter
No load speed
Dimensions
(L x W x H)
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change
without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
• The shape and weight vary depending on the specifications which differ country to country.
Intended use
The tool is intended for cutting in ferrous materials with
appropriate abrasive cut-off wheel. Follow all laws and
regulations regarding dust and work area health and
safety in your country.

Power supply

The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated and can, therefore, also be used
from sockets without earth wire.
For public low-voltage distribution
systems of between 220 V and 250 V
Switching operations of electric apparatus cause voltage
fluctuations. The operation of this device under unfavor-
able mains conditions can have adverse effects to the
operation of other equipment. With a mains impedance
equal or less than 0.18 Ohms it can be presumed that
there will be no negative effects. The mains socket used
for this device must be protected with a fuse or protec-
tive circuit breaker having slow tripping characteristics.
Noise
The typical A-weighted noise level determined accord-
ing to EN61029:
Model LW1400
Sound pressure level (L
Sound power level (L ) : 110 dB (A)
WA
Uncertainty (K) : 3 dB(A)
Model LW1401
Sound pressure level (L
Sound power level (L ) : 110 dB (A)
WA
Uncertainty (K) : 3 dB(A)
With European type safety
guard
With safety guard other than
European type
With European type safety
guard and under cover
) : 102 dB(A)
pA
) : 102 dB(A)
pA
LW1400
530 mm x 295 mm x 640 mm
530 mm x 290 mm x 640 mm
18.7 kg
WARNING:
Wear ear protection.
Vibration
The vibration total value (tri-axial vector sum) deter-
mined according to EN61029:
Model LW1400
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Model LW1401
Vibration emission (a
Uncertainty (K) : 1.5 m/s
NOTE: The declared vibration emission value has
been measured in accordance with the standard test
method and may be used for comparing one tool with
another.
NOTE: The declared vibration emission value
may also be used in a preliminary assessment of
exposure.
WARNING:
The vibration emission during actual
use of the power tool can differ from the declared
emission value depending on the ways in which the
tool is used.
WARNING:
Be sure to identify safety measures
to protect the operator that are based on an estima-
tion of exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it is
running idle in addition to the trigger time).
EC Declaration of Conformity
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
6 ENGLISH
LW1401
355 mm
25.4 mm
-1
3,800 min
500 mm x 295 mm x 640 mm
500 mm x 290 mm x 620 mm
18.3 kg
/II
2
) : 2.5 m/s or less
h
2
2
) : 2.5 m/s or less
h
2