Lengthening Cutting Line; Replacing Cutting Line - Toro 51556 Manuel De L'utilisateur

cut thick, stalky weeds in excess of the unit's
capability. As cutting line wears, for best
performance, lengthen as indicated in
Lengthening Cutting Line procedure.
9. NEVER drag the trimmer spool on the
ground while trimming (Fig. 16). This causes
unnecessary battery drain and spool wear.
10. After each use, feed out some line to prevent line
from retracting into cutting head.
Lengthening Cutting
Line
1. To lengthen line, firmly tap spool on the ground
while the motor continues to run (Fig. 17). The
line will be fed from the spool and cut off to the
proper length by the cutting knife attached to the
shield.
Remember to keep the trimmer 'on' while
lengthening the line. Just tap the trimmer on the
ground; do not hold it on the ground. After the
line feeds out, wait until you hear the line being
cut to the proper length before continuing to
trim.
Note: To help prevent line tangle, tap only
once to lengthen line. If additional line
is required, wait a few seconds before
retapping trimmer head. Do not allow
line to wear too short. Keep line length
at full cutting diameter as much as
possible.
2. Lengthen line only when line has been shortened
by wear. Unnecessary lengthening will waste
line.
Note: The spool may wear during normal use
of the line advance feature and may
require occasional replacement.
EN–8
Replacement spools are available
through your TORO retailer. See
page 11 for accessories.
Replacing Cutting
Line
Replacement line or prewound replacement spools
can be purchased from your local Toro retailer. The
cutting line used by Toro is specially formulated for
use on your trimmer. Other line may not provide the
same high quality performance.
POTENTIAL HAZARD
Use of line other than proper monofilament
cutting line could cause personal injury.
WHAT CAN HAPPEN
Wire or other string-like substances could
cut through clothes, skin, etc. and cause
personal injury.
HOW TO AVOID THE HAZARD
Do not use any type of wire or other
string-like substance.
Use only TORO .050" dia. nylon
monofilament cutting line.