Maintenance; Emissions Maintenance Schedule; Cleaning The Product; Servicing The Product - Toro 51930 Manuel D'utilisation

Maintenance

Emissions Maintenance Schedule

Maintenance, replacement, or repair of the emission control device and systems may be performed by any non-
road engine repair establishment or individual.
Emission Part
Fuel Tank Assembly (Includes
Fuel Lines, Fuel Cap, and Fuel
Filter)
Air Filter
Spark Arrester
Spark Plug
WARNING:
When replacing parts other than engine or
emissions parts, Use only Toro replacement parts.
Use of any other parts may create a hazard or cause
product damage.

Cleaning the Product

■
Stop the product before cleaning.
■
Clean the exterior of the product with a damp cloth.
■
Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to damage from various
types of commercial solvents and may be damaged by
their use.
■
Wipe or scrape the trimmer head and spool area
when they accumulate dirt or clippings.
■
Scrape debris away from air intake vents on both
sides of the motor housing.
CAUTION:
Keeping air intake vents free of grass and debris
prevents motor overheating and possible failure.
Note: Depending on the type of fuel used, the type
and amount of oil used, and/or your operating con-
ditions, the exhaust port and muffler may become
blocked with carbon deposits. If you notice a power
loss with your gas powered tool, you may need to
remove these deposits to restore performance. We
highly recommended that only qualified service tech-
nicians perform this service.

Servicing the Product

■
Check and tighten all fasteners. If any part is
damaged or lost, repair it or replace it.
20
Inspect before Clean every 5
each use hours
X

Replacing the Cutting Line

See Figure 18 and Figure 19.
Use of line other than the proper monofilament
cutting line could cause personal injury.
Follow these steps to replace the cutting line.
1.
Make sure the trimmer head stops rotating.
Contact with a rotating trimmer head could cause
personal injury.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Replace every
25 hours or
yearly
X X
X
WARNING:
Stop the trimmer.
WARNING:
Remove the spark plug boot. See Figure 22.
Remove the retaining cap.
Remove the empty spool.
Clean the trimmer head thoroughly. Inspect the
trimmer head for any damaged or worn parts.
Hold the spool with the spring positioned upward.
Insert the end of the new line into the hole in the
upper threaded area of the spool.
Wind the line around the spool as indicated by the
arrows on the top of the spool until the line reaches
the edge of the spool. Do not wind the line beyond
the edge of the inner ring.
Secure the line temporarily by pushing it into one of
the slotted tabs on the spool.
Measure six inches of line from the slotted tab and
cut the line at that point.
Clean every 25
hours or yearly
X
Maintenance