Primer DSD-11 Guide Rapide page 33

TOTAL COUNTERS
TOTAL TIME
: The total time counter gives the time during which the dryer has been switched on. It
counts in hours.
RUN TIME
: The run time counter gives the time the dryer has been operating. This is not the same as
the number of hours the dryer has been switched on. It counts in minutes.
HEAT TIME
: The heat time counter gives the time during which the heater has been switched on. It
counts in minutes.
T. FILTER
: The T. filter counter gives the time since the filter or fluff bag was last removed for cleaning
(the counter counts the time since the filter cover was last opened). It counts in hours.
FILTER (AL-2):
The Filter counter (AL-2) gives the number of times the AL-2 Alarm, filter cover open,
has been triggered.
FLAME (AL-3):
The Flame counter (AL-3) gives the number of times the AL-3 Alarm, no flame, has
been triggered. This alarm is only triggered in gas-heated dryers.
A. FLOW (AL-4):
in extraction, has been triggered.
DRUM ALARM (AL-8):
in this dryer has been triggered. This alarm is only triggered in belt-driven dryers.
O. HEAT (AL-6):
triggered. This is where the safety thermostat has been triggered and has disconnected the heating
circuit.
32
TOTAL TIME
RUN TIME
HEAT TIME
T.FILTER
FILTER (AL-2)
FLAME (AL-3)
A.FLOW (AL-4)
DRUM ALARM
O.HEAT (AL-6)
The A. Flow counter (AL-4) gives the number of times the AL-4 Alarm, no air flow
The Drum Alarm counter gives the number of times the Drum Alarm fitted
The O. Heat counter (AL-6) gives the number of times the AL-6 Alarm has been
TOTAL COUNTERS
0004
0023
0004
0023
0004
0005
0000
0000
0000