Bushnell TROPHY CAM 119405 Mode D'emploi page 21

4.1.8 Setting Triggering Interval Time
This parameter is only effective in the ON mode. It means that how
long the PIR of the BUSHNELL TROPHY CAM will be disabled after each
triggering in the ON mode. During this time the PIR of the device will not
react to the motion. This parameter has 120 values, ranging from 0 to 59
seconds (with a step of 1 second) and from 1 to 60 minutes (with a step of
1 minute). The default value is 1 minute. During setting the RIGHT or LEFT
key can also be used as an acceleration key in the same way described
in 4.1.7.
The following shows you how to set triggering interval time to "5 Minute"
provided that the previous value is "1 Minute" in MENU state:
a) Push the UP or DOWN key until the parameter "Interval" appears
as shown in the Fig. 12(a) and 12(1).
b) Push the RIGHT or LEFT key until the value changes to "5 Minute"
as shown in the Fig. 12(b) and 12(2).
c) Press OK key for saving setting or MENU key for canceling
operation and exiting. After pressing OK key the selected value
will be no more highlighted, shown in the Fig. 12(c) and 12(3).
Figure 12: Setting Triggering Interval Time
(a)
(b)
(c)
(1)
(2)
(3)
21