Using The Trimmer - Panasonic ES7017 Mode D'emploi

between 100-240V AC.
In some areas, a special plug adap-
tor may be required.
Switch the shaver to the "0 • charge"
position and place it upright into the
charging adaptor with the switch fac-
ing toward the front.
The charge status lamp will glow red
when the shaver is placed on the
correct position. It will flicker red when
the charging is completed.
At the same time, the battery capac-
ity monitor will display the fully
charged condition (see fig. 2 (A)).
The system will turn off in about 10
minutes after the charging has been
completed (see fig. 2 (B)).
You can fully charge the shaver in
one hour if the battery capacity moni-
tor flashes down to the 20% level.
A full charge will supply enough
power for about 20 shaves (three
minutes per shave for a normal
beard).
You can always store your shaver in
the charging adaptor to maintain full
power capacity. This shaver cannot
be overcharged.
Before traveling, charge it fully for 1
hour if you will not be taking the
charging adaptor with you.
Using your shaver
Depress the switch lock button and
slide the On/Off switch upward to turn
the shaver on. Hold the shaver at a
right angle (90°) to your skin (see fig.
3). Start out shaving by applying gen-
tle pressure to your face. Stretch your
skin with your free hand and move
the shaver back and forth in the di-
rection of your beard. You may gen-
OS01G110_ES7017_EUR_en
tly increase the amount of pressure
as your skin becomes accustomed
to this shaver. Applying excessive
pressure does not provide a closer
shave.
System outer foil
(see fig. 4)
System outer foil has a slit blade (a)
between two foils (b). They move up
and down independently to follow the
contours of your face.
The slit blade catches and cuts
longer and lying hairs easily.
For wet shaving
Put a thin layer of shaving foam on
your face which works as a lubricant.
Shaving foam is the most suitable
among many other shaving aids (gel,
soap, cream, etc). Do not put a thick
layer of shaving foam as it may af-
fect the shaver's performance. If the
shaving head is clogged with foam,
simply rinse it under running water.

Using the trimmer

(see fig. 5)
Slide the trimmer handle up to the
position until it clicks in.
Place the trimmer at a right angle to
your skin and move it downward to
trim sideburns.
Cleaning your shaver
(see fig. 6)
For cleanliness and convenience, we
recommend that you clean your
shaver with water and a liquid hand
soap. Regular cleaning will keep your
shaver in good condition while pre-
venting odors or bacteria from devel-
6
6 1/28/02, 9:35 AM