Unpacking Instructions; External Cleaning - Tecfrigo Snelle 350 Mode D'emploi

Operator's guide:

1)Unpacking instructions

2)The handle
3)Round glass shelves
I
4)Square glass shelves
5)Grid shelves
UK
6)Wooden trays
7)Cleaning of the internal glass panels
D

8)External cleaning

9)Connection to mains
E
10)Controls
11)Checking the correct functioning
F
!
WARNINGS
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1. Adults should operate this appliance only. Do not allow children to use the controls or play with it. 2
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4 . Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
DK
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare 5
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. . The 6
FIN manufacturers of this appliance accept no responsibility for the consequences of misuse in contravention
of these safety instructions. It further reserves the right to carry out improvements without prior notice.
8 . Avoid installing the cabinet directly in line with sunlight. . Nevere install the appliance near sources of
B
heat, such as radiators, stoves, etc.
11 .Ensure that the products displayed on the shelves and grills do not hang over the edges.
GR
air or products to be refrigerated should cause ice to form on the evaporator, we recommend stopping the
compressor and placing the goods in special refrigerated containers, kept at the same temperature, until
CZ
defrosting is completed;if this is not carried out the compressor will continue to operate leading to a
wasteful consumption of electricity and poor performance.
EE
it is indispensable to keep the door open at least 10 cm. 14. Do not keep the neon light up if the
refrigeration is off.
LV
! Our products are for internal use only do not install outside restaurants, shops
LT
1. UNPACKING INSTRUCTIONS
H
1a . Cut surrounding tape. Remove the cardboard packaging by sliding upwards.
the wooden crate with care. . Insert forks of fork-lift truck between the appliance and pallet or crate .
3 . Lift the appliance. . Remove the pallet or crate. . Place the appliance on a horizontal level surface
M
6.
Pay attention anything is left inside the packing.
type, for easier disposal (See picture 1).
PL
2. THE HANDLE
1 . The handles will be found in a package inside the appliance.
SK
the two screws inserted on the holes already. Tighten them with care.
down until it clicks into place
SLO
3. ROUND GLASS SHELVES
1 . These shelves, to be found in the cardboard box, should be slid into the supports placed in the vertical
rotating frame (first introduce the mirror shelf, in the lower position)
using the screws contained in the pack inside the appliance, with the plastic part towards the glass.
Tighten with care (see picture 3).
4. SQUARE GLASS SHELVES
1 . The supports and the suction cups (n° 4 for each shelf) are into a pack, inside the appliance.
the suction cup heads into the support holes, pushingdownwards
hook on the vertical frames slits
carton box, should be put on their supports. . First place the mirror shelf, in the lower position. . Press
the other shelves on the wet suction cups
5. GRID SHELVES
1 .The support are in a pack inside the appliance. . Fix the supports, inserting the hook on the vertical
(B),
frames slits
on the supports, their raised edge opposite to the door
6. WOODEN TRAYS
For the Phasta models, the manifacturer install the wooden trays already
7. CLEANING OF THE INTERNAL GLASS PANELS
1. Only clean the internal component and glass panels with a soft,wet sponge and a neutral detergent.
2 . Dry with care using a soft cloth.
8. EXTERNAL CLEANING
1 . For the glass panels use the same products as used for the internal cleaning.
protection tape from the steel panel and from the grids (see picture 7).
Operator's guide
10 . Keep the ventilation grills free from obstruction for at least 30 cm.
2
4
(see picture 2).
R
Model
Q
Model
(B), pushing them downwards
(see picture 4).
G
Model
pushing them downwards
PHASTA
Model
12)Internal cleaning
13)Replacement of internalight
14)Replacement of the door magnetic gasket
Maintenance manual (Page 48):
1)Cleaning the condenser
2)Cleaning the evaporator
3)Replacement of a glass panel
4)Wiring diagram diagram of refrigeration unit
9
13 . If the appliance is not working and unused,
5
7.
Separate the packing materials according to their
2. Fix the base part of the handle using
2.
(A). 3
(C). 4
5
2
(C ). 3
. The grid shelves are into a carton box. Place the grids
(see picture 5).
6
3
12 . If damp
Remove the nails from
3. Place the plastic part and press
The shelves have to be fastened
. Fix the support, inserting the
. The shelves, to be found into a
(see picture 6).
2 . Remove the
. It
7
2. Insert
6