Teka LP 800 S Manuel D'emploi Et D'entretien page 11

Installation
Positioning the Appliance
Position the appliance in the desired location.The back should
rest against the wall behind it,and the sides,along the adjacent
cabinets or wall.The dishwasher is equipped with water supply
and drain hoses that can be positioned on the right or the left to
facilitate proper installation.
Levelling the Appliance
Once the appliance is positioned,adjust the feet (screw them in
or out) to level the dishwasher.In any case,the appliance should
not be inclined more than 2 . If the appliance is level,it will help
ensure proper performance.
Cold Water Connection
Connect the cold water supply hose to a threaded 3/4(gas) connec-
tor and make sure that it is fastened tightly in place (see Fig 1).
If the water pipes are new or have not been used for an ex-
tended period of time,let the water run to make sure that the
water is clear and free of impurities.If this precaution is not taken,
there is a risk that the water inlet can get blocked and damage
the appliance.
Hot Water Connection
The water supply to the appliance can also be connected to the
house's hot water line (centralised system,heating system),as
long as it does not exceed a temperature of 60 .
In this case,the wash cycle time will be shortened by about 15
minutes and the wash efficiency slightly reduced.
The connection must be made to the hot water line following the
same procedures as those for the connection to the cold water
line.
Anti-Flooding Protection
The dishwasher is equipped with a system that stops the supply
of water in the event of a problem with the water supply hose,or
leaks within the unit,in order to prevent damage to your home.If
for any reason the box containing the electrical components hap-
pens to get damaged,remove the plug for the appliance from the
socket immediately.In order to guarantee that the anti-flooding
feature operates properly, the"A" box with water supply hose
must be attached to the water supply tap as shown in Fig .1.No
other type of connection is acceptable.The water supply hose
must not,under any circumstances,be cut,as it contains electri-
cal parts which are live.If the length of the hose is not adequate
to make a proper connection,the hose must be replaced with
one which is long enough.This hose is available upon request
from specialised retailers and service centres.
GB
Drain Hose Connection
Insert the drain hose into a drain pipe with a minimum diameter
of 4cm,or let it run into the sink,making sure to avoid bending or
crimping it.Use the speical plastic support that comes with the
appliance (see Fig.2).The free end of the hose must be at a
height between 40 and 100 cm and must not be immersed in
water.
Attention:
The special plastic hose support must be solidly fastened to the
wall to prevent the drain hose from moving and allowing water to
spill outside the drain.
Electrical Connection
After making sure that the voltage and frequency values for the
current in the home correspond to those on the rating plate
(located on the stainless steel inner door of the appliance) and
that the electrical system is sized for the maximum voltage on
the rating plate,insert the plug into an electrical socket which is
earthed properly (the earthing of the appliance is a safety re-
quirement mandated by law).
If the electrical socket to which the appliance must be connected
is not appropriate for the plug,replace the plug ,rather than us-
ing adpators or the like as they could cause overheating and
burns.
.10.
Fig.1
Fig.2