Skytec HAPPY FLASH SLR-563 Mode D'emploi page 6

Replacement of the lamp:
- Unplug the unit fro the mains and wait at least 10 minutes to allow the unit to cool down.
- Turn the see-through cap of the unit counter clockwise to open it.
- Remove the three small screws and take the old lamp out.
- Insert the new lamp carefully. Do not touch the lamp with bare hands.
- Put the screws and the cap back in place. The unit is now ready for use.
Specifications
Power supply: ...............................................................................230Vac/50Hz, 6,3A
Flash speed: ...................................................................... 2 - 14 flashes per second
Lamp:..................................................................................................... BH0647 60W
Dimensions:................................................................................257 x 212 x 212 mm
Weight:................................................................................................................. 2 kg
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the warnings
contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety recommendations and
warnings. This is also applicable to all damages in whatever form.