Switching Between Fahrenheit And Celsius; Care And Cleaning - vivocare Speedy Mode D'emploi

Switching between Fahrenheit and Celsius

1. Make sure the device is off. (Or you can turn off the device by pressing and holding the
"On/Off/Memory" button for 3 seconds.)
2. Hold onto the "Start" button, then press and hold the "On/Off/Memory" button until
°C appears on the LCD.
3. Press the "On/Off/Memory" button to select the desired scale °C or °F, once you decide
the scale, wait for 5 seconds and the setting will be confirmed while you will hear 2
short beep sounds.
How to measure object temperature
When you want to measure object temperature, you have to change to Object Mode.
1. Make sure the device is turned off.
2. Press and hold down the "Start" button. After about 3 seconds,
the display will show this sequence:
3. Release the "Start" button when the desired measurement mode
is shown and 1 short beep sound will be heard.
4. When you are at Object Mode, press the "Start" button to get the real temperature.
Note:
1. Applications include temperature measurements for Water, Milk, Cloth, Skin or ot-
her object.
2. This mode shows the actual, unadjusted object temperatures, which is different
from the body temperature.

Care and cleaning

1. The probe is the most delicate part of the thermometer. Use with
care when cleaning the lens to avoid damage.
2. After the measurement, please use the cotton swab with the Alco-
hol (70% concentration) to clean the inside of the probe, including
lens and metal parts.
3. Allow the probe to fully dry for at least 5 minutes.
4. Storage temperature range: It should be stored at room tempera-
ture between -25~+55°C, RH<=95%
5. Keep the unit dry and away from any liquids and direct sunlight.
6. The probe should not be submerged into liquids.
7. Please check the device if damaged once it falls. If you can't make
sure of it, please send the complete device to the nearest retailer
for re-calibration.
8. Holding the thermometer too long may cause a higher ambient
temperature reading of the probe. This could make the body tem-
perature measurement lower than usual. Please try not to touch
the thermometer probe part for avoiding the incorrect reading.
14