Moving The Wet/Dry Vacuum; Blowing Feature - Craftsman CMXEVBE171550 Guide D'utilisation

Moving the Wet/Dry Vacuum (Fig. M)
Should it become necessary to pick the Vac up to move it,
use the Dust Drum Handles located at the bottom of the
Dust Drum Latches.
To maneuver the Vacuum, the Carry Handle on top of the
Powerhead Assembly should be used.
Fig. M
Carry
Handle
Dust Drum
Latches (2)
Dust Drum
Handles (2)
Dust Drum
10
I
Blowing Feature (Fig. N)
Your Wet/Dry Vacuum features "Full Blowing". It can blow
sawdust and other debris. Follow the steps below to use
your Vacuum as a Blower.
1. Locate the Blowing Port of your Wet/Dry Vacuum.
2. Insert the larger end of the Hose into the Blowing Port
of the Vacuum.
3. (Optional) Attach the Extension Wand to the swivel
end of the Hose.
4. Turn the Vacuum ON and you are ready to use your
Vacuum as a Blower.
WARNING:
!
Always wear safety eyewear complying with ANSI Z87.1
(or in Canada, CSA Z94.3) before using as a blower.
WARNING:
!
To reduce the risk of injury to bystanders, keep them
clear of blowing debris.
CAUTION:
!
Wear a dust mask if blowing creates dust which might
be inhaled.
CAUTION:
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac / Blower for an extended
time or in a noisy area.
Fig. N
Powerhead
Assembly
Blowing
Port
Hose