Replacing The Backup Battery - ADE CK 2010 Mode D'emploi

You can also completely darken the display indication. As
soon as you press a button, the content is displayed with
lower brightness.
Switching on alternate display
− By repeatedly pressing the - button, you can select the
display indication.
dP-1
dP-2
If the time is displayed permanently later, you can
press
5 seconds.

Replacing the backup battery

1. Open the battery compartment on the underside using
a fine Phillips screwdriver.
2. Remove the battery compartment cover and remove
the old battery.
3. Slide the new battery under the two retaining tabs and
then push them down with a little force so that the
battery is firmly under the retaining tab and audibly
clicks into place. Pay attention to the correct polarity
(+/-). The plus pole (+) must point upwards.
4. Replace the battery compartment cover and secure the
battery compartment cover with the Phillips screw.
40
Time is displayed permanently
Time and temperature are displayed
alternately on the display.
briefly to display the temperature for
CK 2010 digital alarm clock