Memory Function - Beurer BF66 Mode D'emploi

Memory function

•
A maximum of 10 sets of results are saved automatically in the measured value memory.
•
Incorrect measurements resulting in "Err" are not saved.
•
Weight measurements (without analysis measurement) are not saved in the memory.
Retrieving measured values from the memory
The last 10 measurements can be retrieved.
• Switch on the scale by tapping the scale briefly, forcefully and in an easily audible manner.
• If necessary, press the
personal user data is saved.
• When "0.0" appears, press the function buttons
last measured value for this variable.
• "End" appears on the display if a value has not been saved.
• Press the relevant function key repeatedly to display the measured values one after the
other. The date indicates when the measurement was taken. If several measurements
were saved on one day, the value saved in the last memory position is displayed first.
• "End" appears after the last measured value is displayed.
• You can view any other measured variable together with stored related values by press-
ing the relevant function button
• If no buttons are pressed for a short time, "0.0" appears on the display and the scale is
ready for measurement.
Important:
For bone mass, basal metabolic rate (BMR) and active metabolic rate (AMR), on-
ly the last measured value is saved because these values hardly ever change.
9 Evaluation of results
Trend display
This scale has a trend display, which compares the current measured value with the average
calculated from the last 5 measurements.
Display Meaning
Current value is higher than the average of the last 5 measurements
Current value is lower than the average of the last 5 measurements
Current value is the same as the average of the last 5 measurements
Important:
Note that trends are only displayed for body weight, body fat, body water and
muscle proportion.
Requirement: at least 5 measured values must be saved.
22
button several times to select the memory position where your
to retrieve the
.