COMAC CA 15 ECO Manuel D'utilisation page 9

CA 15 – Eco
CA 15 – Eco
GB
WARNING:
Read carefully the instructions in this booklet and keep it handy for further reference. Failure to observe these warnings can
Affect the safety of the vacuum. The packaging components (plastic bags, staples, etc.) can be dangerous and must therefore
be kept out of the reach of children and handicapped persons, etc. After opening the package, check to make sure that the
vacuum is intact and complete. In case of any irregularity or missing pieces, as in the case of all future and eventual repairs,
contact an authorized service centre which can guarantee the use of original parts. Before connecting the vacuum to electricity,
make sure that the electrical specifications on the technical data label of the unit correspond to those of your electrical outlet.
This unit must be used only for the specific purposes for which it has been manufactured, namely: cleaning of inert surfaces,
vacuuming of solids which are non-flammable and non-explosive. Any other use must be considered improper and dangerous.
Avoid bringing the attachments in close distance of delicate organs such as ears, eyes, mouth, etc.. Do not leave the vacuum
unguarded within the reach of children or handicapped persons. The vacuum must not remain connected to electricity when
not in use. Before carrying out any cleaning or maintenance work on the vacuum, make sure that the vacuum is not connected
to electricity. Do not immerse the vacuum in water. Do not use any solvents. The manufacturer cannot be held responsible for
any damage to persons, animals or objects, from the improper or unreasonable use of this vacuum, or from failure to observe
the warnings in this booklet or from the failure to carry out the instructions therein.
DESCRIPTION
1. HEAD COVER 2. ROTARY KNOB FOR COVER RELEASING 3. SPOUT
4. FILTER FOR AIR DISCHARGE 5. ON/OFF SWITCH 6. LABEL WITH TECHNICAL DATAS
7. CORDSET
INSTRUCTION MANUAL
Attention! Before using the machine, read carefully this manual.
The vacuum can be used on to suck solids substances. Do not put the working tool near eyes, ears or mouth.
DO NOT SUCK INFLAMMABLE OR EXPLOSIVE SUBSTANCES
HOW TO MAKE THE MACHINE WORKING
Pull the machine out of the box. Join the flexible hose to the spout (fig. 1).
CONNECTION OF THE MACHINE TO THE ELECTRICAL SYSTEM
Before joining the machine to the socket, check if the cordset is damaged. If the electrical data on the plate are as the ones
of the electrical system, put the plug of the machine in the socket.
UTILIZATION
The machine can be used only to suck solid substances. Press the ON/OFF switch, the machine is ready for work (fig. 2).
CLEANING AND REPLACEMENT OF THE FILTER FOR AIR DISCHARGE
(fig. 3) The machine is equipped with a special filter for air discharge. Removing the little drawer of the machine the filter can
be cleaned by sucking or blowing it. If it is necessary to replace the filter, it can be removed from the little drawer and
replaced with a new one.
REPLACEMENT OF THE FILTER BAG
ATTENTION! Do not use the machine without the filter bag.
Remove the cover by by turning the rotary knob clockwise. Remove the „old" filter bag. Put the new filter bag over the spout
(fig. 4). Close the cover by turning the rotary knob anticlockwise and the machine is ready for work again.
SUBSTITUTION CABLE
ATTENTION! If the cable is damaged, it must be replaced by an authorized technician from the manufacturer or in any
case by a professional qualified person, to avoid any risk.
pag. 9