Linking Parent Unit And Baby Unit - Philips Avent SCD565 Mode D'emploi

4.2 Linking parent unit and
baby unit
Press and hold the on/off button 3 on the
1
baby unit for 2 seconds.
The nightlight, the battery status light and
•
the power-on light go on briefly.
Press and hold the on/off button 3 on the
2
parent unit for 2 seconds.
• The display goes on and briefly displays all
indicators and symbols. Then the indicators
and symbols fade out and the battery status
indicator appears.
Note:
D
When you switch on the parent unit for the
first time or after a reset, you have to select
your preferred display language (see 'Language'
in chapter 'Menu of the parent unit').
• The 'link' light on the parent unit starts
flashing red and the message 'LINKING'
appears on the display.
• When the parent unit and baby unit are
linked, the 'link' light turns solid green.
The signal strength indicator and the
message 'LINKED' appear on the display.
• If no connection is established within
10 seconds, the message 'NOT LINKED'
on the display alternates with 'LINKING'.
If still no connection is established after
30 seconds, the parent unit starts to beep and
only the message 'NOT LINKED' is shown.
7