Stainless Steel Surfaces; Control Panel - GE P2S975 Manuel D'utilisation

Press down and pull out.
Stop guide
Rail

Stainless Steel Surfaces

Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless steel
cleaner or polish. Always wipe the surface
in the direction of the grain. Follow the
cleaner instructions for cleaning the
stainless steel surface.

Control Panel

If desired, the touch pads may be turned off
before cleaning.
See the Range Lock-Out section.
Clean up splatters with a damp cloth.
Oven Heating Element
Do not clean the broil element. Any soil
will burn off when the element is heated.
Removable Oven Floor
To remove the oven floor for easier cleaning:
Remove the oven door using the
instructions in the Lift-Off Oven Door
section.
Press down and pull out the
removable oven floor.
Storage Drawer Removal
To remove the drawer:
Pull the drawer out until it stops.
Lift the front of the drawer until the
stops clear the guides.
Remove the drawer.
(on some models)
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer nearest you,
please call our toll-free number:
National Parts Center
GEAppliances.com
You may also use a glass cleaner.
Remove heavier soil with warm soapy
water. Do not use abrasives of any kind.
Turn on the touch pads after cleaning.
Clean the oven floor with warm
soapy water.
When reinstalling the oven floor, be
sure to slide it all the way to the back
of the oven.
IMPORTANT: Always replace the
removable floor before the next use.
To replace the drawer:
Place the drawer rails on the guides.
Push the drawer back until it stops.
Lift the front of the drawer and
push back until the stops clear the
guides.
Lower the front of the drawer and
push back until it closes.
GEAppliances.com
1.800.626.2002
33