User Manual - Toolland TL73003 Guide Utilisateur

TL73003
Loading Ramp

User manual

Please read the manual thoroughly before bringing this device
into service. If the device was damaged in transit, don't install
or use it and contact your dealer.
Safety Instructions
Always wear protective gloves.
Warning Risk of property damage or bodily
injury.
-
Always respect the safety instructions.
-
All persons not involved in the loading process must
stand clear of the loading ramp.
-
Avoid working alone. If an accident happens, an
assistant can bring help.
-
Keep work area well lighted.
-
Dress properly. Do not wear loose clothing or
jewelry as they can be caught in moving parts.
Protective, electrically non conductive clothes and
non skid footwear are recommended when
working. Wear restrictive hair covering to contain
long hair.
-
Use eye and ear protection.
-
Keep proper footing and balance at all times.
-
Wear security gloves and shoes when handling the
ramps.
-
Only use the device for its intended purpose. Using
the device in an unauthorised way will void the
warranty. Do not exceed the maximum capacity.
-
Always be careful. Do not use the ramp if you are
tired.
-
Check the ramp for stress fractures and breakage
before every use. All damaged
-
parts must be replaced by a qualified technician.
-
Only use original spare parts to replace parts or
accessories. Using other parts will void the
warranty. Only use spare parts that are meant to be
used with this device.
-
For your own safety, have the device maintained by
a qualified technician.
-
All loading and unloading must be done on a flat,
level, dry surface. Make sure the flange faces down
and the tongue edge fully contacts the tailgate or
bed of vehicle.
v 0.3 - 23/12/2014
-
Make sure the ramp is clean of dirt, debris, grease
and oil.
-
Make sure all parts are included in the package
when unpacking.
Assembly
Make sure the flange faces with the tongue down.It is
designed to keep the ramp from moving once the weight
of the load is on the ramp.
Line up the holes on the tongue with the holes on the
ramp. Insert the bolts from the top and secure with
washers and nuts.
Use
-
Make sure no persons or animals are under the
ramp or truck bed during the loading process.
-
Never load a vehicle while its engine is running. Let
the vehicle cool down before loading it.
-
Never exceed the maximum weight of 200 kg. Load
the vehicle slowly. Do not drop load onto ramp. This
may reduce load capacity and possibly lead to
personal injury and /or property damage. All
loading and unloading must be done on a flat, level,
dry surface.
Loading a Motorcycle (3 persons)
-
Make sure the ramp is clean of dirt, debris, grease
and oil.
-
The tongue edge must face down fully and touch
the tailgate of the truck.
-
Position a person on each side of the motorcycle.
Each person should hold either the front handlebar
or the front fork, where they can steer/guide the
vehicle.
-
They should position their other hand toward the
rear of the seat or the rear fork. The third person
can start the process from the rear, by pushing,
then move to the inside of the truck bed to take
control of the motorcycle when it enters the truck
bed.
-
Put motorcycle in neutral.
-
As the motorcycle contacts the ramp, make sure
the ramp remains straight, and the tongue edge
remains in contact with the truck bed. If not, roll
back and slowly start over.
Technical Specifications
User manual
p. 3 / 14