General Guidelines; User Manual - Toolland DT20050 Mode D'emploi

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Toolland. Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
2.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
 Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
 Note that damage caused by user modifications to the device is not covered by the warranty.
 Keep the device away from children and unauthorised users.
 Do not operate the pump lever continuously without spraying. Too much pressure can damage the pressure
sprayer.
 Wear protective clothing, mask and gloves when spraying substances which could be harmful. Avoid
inhaling the sprayed substances and stand with the wind in the back. Never spray in the direction of other
people or pets. Never use the pressure sprayer with substances such as acids, alkali and highly toxic
pesticides.
 Clean and rinse the pressure sprayer thoroughly after each use by spraying 1 to 2 litres of clear water. Do
not dispose of your clean-up water into the sewer system but spray onto the treated crops.
 Lubricate the moving mechanic parts such as the suction tube inside the pump with some petroleum jelly.
3. Assembly
1. Fit the lance assembly to the sprayer by means of the flexible hose.
2. Remove the nut fitted to the lance.
3. Insert hose through nut.
4. Push the hose fitting fully onto the lance connector.
5. Screw nut tightly onto lance.
6. Attach the other end of the hose to the container using the above method.
7. Ensure that the hose is fully pushed on and that the nut is screwed down tight.
8. Fit the carrying strap by threading the expandable ring through the hole in the lug moulded into the
container base.
9. Fit the other end of the strap through the slot in the top lug and thread through the metal buckle and adjust
length to suit.
4. Operation
 Ensure that the hose is securely attached to the sprayer and the lance and the locking nut are tight.
 Check that the liquid which you intend to use is suitable (see the spraying chemical section).
 Fill the container to the desired level taking care not to exceed the maximum fill mark.
 Screw the pump firmly home to ensure an airtight seal.
 Operate the pressure release valve manually by pulling the blue knob upwards to ensure it is functioning
correctly.
 Release the pump handle by pressing down and turning anti-clockwise.
 Pump to pressurize the container.
 When the correct operating pressure has been reached, the pressure release valve will vent to discharge
excess air.
 The container is adequately pressurized and does not require further pumping.
V. 03 – 10/11/2015
DT20050

USER MANUAL

2 ©Velleman nv