Husqvarna RA850 Manuel D'utilisation page 11

2. Remove the 4 screws (D), the lower blade (E) and
the shim (F).
3. Remove the 4 screws (G) and the top blade (H).
4. Install the blades in opposite sequence. Tighten the
screws equally when you install the blades.
To adjust the clearance between the
blades
WARNING: Use protective gloves when you
hold the blades.
1050 - 002 - 12.04.2019
1. Remove the lower blade, refer to
2. Remove the shim.
D
E
F
3. Install the lower blade. Tighten the screws equally
To replace the cutting attachment
guard
•
•
G
H
blades on page 10 .
Note: Save the shim until it is time to replace the
blades.
when you install the blades.
WARNING: Use protective gloves when you
hold the blades
Remove the 2 screws (B) and the cutting attachment
guard (A).
Install the new cutting attachment guard (A) with the
2 screws (B). Tighten the screws equally.
B
To replace the
A
11