6
Important Safety Instructions
▪ Devices may be used by persons with reduced physical, sensory or
mental capacity or little experience and/or knowledge if they are
supervised or trained in how to use the equipment safely. After this
they must have understood the resulting risks.
▪ This device may not be used by children. The device and its cable
must be kept out of the reach of children.
▪ Children should be supervised to ensure that they do not play with
the device.
▪ The device must always be unplugged from the mains during
inspection, in the event of an operating malfunction and prior to
assembly, disassembly or cleaning.
▪ If the device cable is damaged, it must be replaced by the manuf-
acturer, its customer service team or another similarly qualified
person to avoid hazards.
Prior to use
Please read the instruction manual carefully. It contains important
information about using the device, as well as safety and maintenance
advice. Please store it carefully and if necessary
pass it on to subsequent users. The device should only be used for its
designated purpose in accordance with these usage instructions. Please
pay attention to the safety instructions during use.
Technical data
Rated voltage:
Power consumption:
Protection class:
Safety information
▪ This device can be used to mill coffee/espresso beans only.
▪ Maximum filling quantity of the bean hopper: 280 g
▪ Warning! The collection container for the coffee powder has a
capacity of around 120 g only. If it is overfilled, the device could
stop. Therefore empty the collection container in good time.
▪ Do not pull or clamp the cable across sharp edges. Do not allow it
to hang down and protect it from heat and oil.
▪ Do not place the device on hot surfaces such as hotplates etc, and
do not operate close to naked flames.
▪ Do not remove the plug from the socket by the cable or with wet
hands.
▪ Cease operating the device and unplug it immediately if:
⋅
the device or the mains cable is damaged;
⋅
you suspect a defect after dropping the device etc.
In these instances send the device for repair.
▪ The mains cable should be removed:
⋅
in the event of malfunction during operation
⋅
prior to every clean
⋅
after use.
220 - 240 V~ 50/60 Hz
150 W
II