Signaling Lamps; Accessories Supplied With The Unit - Technibel Climatisation REVE 245CH2O Notice D'installation

1. Wireless remote control unit

2. Signaling lamps

3. Supply air deflector
4. Lateral air intake grilles
5. Front air intake grille
6. Air filter
7. Electric cable with plug
8. Inlet/outlet hole for municipal water and condensate drainage
EG
9. Suspension panel
10. Service tube for condensate discharge
9
SIGNALING LAMPS
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.

ACCESSORIES SUPPLIED WITH THE UNIT

1. FULL SCALE DIAGRAM (1pcs.)
2. RAWL PLUGS + SCREWS (15pcs.)
3. REMOTE CONTROL UNIT (1pcs.)
4. BATTERIES FOR REMOTE CONTROL (2pcs.)
1
8
7
1. Receiver : receives signals transmitted from the remote
2. Timer lamp: This lamp lights up when the system is
3. Standby lamp: This lamp lights up when the air
4. Operation lamp: This lamp lights up during operation.
5. Operation button (without remote control): Push the
4
5
6
10
control.
being controlled by the timer or sleep mode.
conditioner is connected to the power and ready to
receive the remote control command.
It blinks once to announce that the remote control signal
has been received and stored. It blinks continuously
during the protection modes (defrosting, etc.).
button to change from one operation mode to the other
as shown here following.
Cooling only models
2
3
4
2
3
4
Heat pump models
1