Service Pipe - Technibel Climatisation REVE 245CH2O Notice D'installation

Sweep function
The flap starts moving up and down to deliver air
over the sweep range.

SERVICE PIPE

Use the service pipe (10) for the drainage of dripping water during the installation.
IMPORTANT
At the end of the operation close the tube with its stopper.
If you want to use the service pipe as principal condensation water
discharge, follow the instructions on page number 5.
NOTES
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
10
14
• The flap automatically closes when the unit
is off.
• During the heating operation the flap position
changes according to the settings specified
with the remote control.
CAUTION
EG