Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RECORD ( )
Use this to record to an external USB storage device. Press it once
to enable recording standby, and press it again to start recording.
(page 29)
Press it during recording to divide the file at that point (page 30).
Stop ( )
Press this button to stop playback.
Press this button to stop recording to USB.
Play (
)
Press this button to start playback.
When in USB recording standby, press this to start recording.
Pause ( )
Press this button to pause playback or recording.
Press this button again to resume playback or recording.
J
Stop ( )
Press this button to stop playback.
Press this button to stop recording to a tape.
Pause ( )
Press this button to pause playback or recording.
Press this button again to resume playback or recording.
Fast-forward/Rewind (
Press these buttons to fast-forward/rewind the tape.
Reverse/Forward play (
Press these buttons to start playback of the back/front side of a
tape.
Press during tape playback /recording standby to restart
playback/recording.
RECORD ( )
Use to record to a tape. Press it once to enable recording standby,
and press it again to start recording (page 32).
COUNTER RESET
Press this button to reset the tape counter to "0000".
K
REC LEVEL ( – / + )
Use these buttons to adjust the recording level.
NOTE
To simplify explanations, instructions in this manual might refer only to
the main unit or the remote control. In such cases, the same controls
on the remote control and main unit will operate similarly.
/
)
/
)
Remote Control Unit (1)
The included remote control allows this unit to be operated from a
distance.
When using the remote control, point it towards the remote sensor on
the front panel of the main unit.
Even if the remote control unit is used within its effective range,
operation by remote control might not be possible if there are any
obstacles between the unit and the remote control.
If the remote control unit is operated near other devices that
generate infrared rays, or if other remote controls that use infrared
rays are operated near the unit, this unit and the other devices
might not operate correctly.
Battery installation
1. Remove the battery compartment cover.
2. Insert two AAA (R03) dry batteries. Make sure that they are inserted
with their positive ( ) and negative ( ) poles oriented correctly.
3. Close the cover.
Battery replacement
If the distance from the main unit that the remote control works
effectively decreases, the batteries are probably exhausted. Replace
the batteries with new ones when this happens.
For more information about the collection of batteries, please contact
your local municipality, your waste disposal service or the place where
you purchased them.
13
Publicité
Chapitres
Table des Matières
Dépannage
