Transport; Operation - Trotec MD 01-10 Manuel D'utilisation

Caution!
To avoid damages to the device, never
operate the device without an air filter
inserted!
Danger!
Dangers can occur at the device when it
is used by untrained people in an
unprofessional or improper way! Observe
the personnel qualifications!
Behaviour in the event of an emergency
1. Disconnect the device from the mains power in an
emergency.
2. Do not reconnect a defective device to the mains
power.

Transport

To make the device easier to transport, it is fitted with
a carry handle.
Before transporting the device, proceed as follows:
1. Switch off the device at the mains switch (see
chapter "Operating elements").
2. Remove the mains plug from the mains socket.
Do not use the power cable to drag the device!
3. Empty the condensation tank. Check for dripping
condensation.
After transporting the device, proceed as follows:
1. Set the device in an upright position after
transport.
2. Wait one hour before switching the device on!
Storage
When out of use, store the device as follows:
• dry,
• with a roof overhead,
• in an upright position where it is protected from
dust and direct sunlight,
B - 5
• with a plastic cover to protect it from invasive dust,
if necessary.
• The storage temperature is the same as the range
given for the operating temperature in the chapter
"Technical Data".

Operation

• After being switched on, the device operates fully
automatically until the float indicates that the
condensation tank is full and the device switches
itself off.
• So that the built in sensor can correctly detect the
humidity, the fan continues to operate until the
device is switched off.
• Avoid open doors and windows.
Positioning
When positioning the device, observe the minimum
distance from walls of other objects as described in
chapter "Technical Data".
• Set the device in a level and stable position.
• If possible, set the device in the middle of a room
and keep it away from sources of heat.
Operating Manual – Dehumidifier MD 01-10
A
C
D
B
C
EN