ENGLISH
NOTE: Only rinse the shaver-/trimmer head under running water. Do not wash the whole
product as damage will occur.
STORAGE
Always store this appliance and cord in a moisture-free area. Do not store it in
temperatures exceeding 140°F (60°C).
Do not wrap the cord of the charging adaptor around the appliance.
CLEANING
Ensure the shaver is switched off and unplugged from the mains outlet.
Release the head assembly from the shaver body. (DIAGRAM A)
Gently tap the shaver head on a flat surface to remove the hair particles, and clean with
the cleaning brush supplied. (DIAGRAM B)
Never use the cleaning brush on the foils as damage may occur.
Close the shaving unit.
At regular intervals, put a drop of lubricant onto the shaving frame/head.
REPLACING THE FOIL & CUTTER
To ensure the continued highest quality performance from your shaver, we recommend
that foil and cutter are replaced regularly.
Signs that your foil and cutter need replacing:
1. Irritation: As foils get worn, you may experience skin irritation.
2. Pulling: As the cutters wear, your shave may not feel as close and you may feel your
cutter pulling your hair.
3. Wear through: You may notice that the cutters have worn through the foils.
TO REPLACE THE FOIL
Remove shaving head assembly by pressing the buttons on both sides of the shaver.
(DIAGRAM A)
Insert fingernail between side of screen and head assembly. Pull away from notches.
(DIAGRAM C)
To reassemble, slide the foil into the shaving head and click into position. Only hold foil
by plastic frame to prevent damage. (DIAGRAM D)
TO REPLACE THE CUTTER
Remove head assembly as shown. (DIAGRAM A)
Grasp cutter between thumb and forefinger and pull upward. (DIAGRAM E)
Snap new cutter into top of oscillator tip.
Note: Do not press on the cutter ends as this may cause damage. (DIAGRAM E)
Replacement cutter & foil available: SP410
4
100595_REM_IFU_MB4110_21L.indd 4
100595_REM_IFU_MB4110_21L.indd 4
12.08.10 20:59
12.08.10 20:59